SLA DLP Resin - Fun To Do - F1 - Black
F1+ Blend is the blend especially made for the formlabs Form1 and Form1+ printers.
The F1+ Blend is available in four colours: Clear, White, Grey and Black.
The F1+ is not only compatible with the machine but also with the Formlabs PreForm software. Just choose the appropriate colour and the V01 setting. Then Dial in the layer height. Because of the very high detail of the blend, especially the Black version, astonishing detailed results are achievable at 0.05 and 0.02mm layer height.
The F1+ blends are compatible with our pigments. Depending on the pigments added, you might have to choose a differend colour setting in the PreForm software this might take some experimenting. Lighter colours need lighter colour settings in the software. Beware,the darker settings in the software makes the machine emit more energy, so don't use the Black setting for a Clear/transparent colour
All SLA DLP resins come with a health warning. Avoid skin contact, use gloves whenever touching uncured resin and make sure to have a well ventialed work space. Make sure to keep it our of reach of any persons that might now be knowing of the effects.
Curing times of 0.5 seconds for 0.02mm layers are easily achieved on standard Dlp printers with an average light source of around 240Watts.
A broad range of reactivity!
The resin have a very broad range of reactivity, it extends from the very short wavelengths of 225nm to the near/visible wavelengths of 415nm. By incorporating a very smart blend of photo initiaters and sensitizers, almost any light source can be used to initiate the polymerization process of our resins. No need to modify your expensive DLP projector! Do you have a laser SLA machine? or perhaps a DLP printer with a LED source of illumination? As long as the wavelength is between 225nm and 415nm, it will work, and it will work fast!
The Fun To Do resins have an ultra low shrinkage!
Where 3.5% is regarded little shrinkage, we have the limited the shrinkage to 0.5%.
It is basically what you see is what you get. 3.5% seems to be little but if you take an object of 10cm (100mm) 3.5% is 3.5 mm which is nearly half a centimetre! This is huge compared to the 0.5mm the Fun To Do Resins achieve.
A natural resistance to water and most chemicals!
Our resins have a natural resistance against water, in liquid form it is highly hydrofobic. Once fully cured there is hardly any chemical that can disolve our resins. Especially the Industrial blend has a high resistance to chemicals. Cured prints have been withstanding the elements and various chemicals for more than a year now! To see which chemicals have been tested click here
User Friendliness makes you want to build more!
When designing the resins we have spent quite some effort in making the resin as user friendly as possible. These efforts have resulted in a series of low odor resins with minimal skin irritation.
Affordable resins make it possible for you to build more!
By using our affordable resin you can afford to experiment, extend your knowledge about supports, exposure times, material thickness without having to think about the costs of the materials all the time.